Basic Technical Paper

CopyFUN® Grey CopyFUN Grey is a transfer for hard materials. The transfer can be used on various types of products, such as, wood, cardboard, metal, aluminium and pottery. You need a coated object to be able to print on pottery. No special coating is required for wood, cardboard, metal or aluminium. You can print any product using CopyFUN Grey by using an A-pad.
Specifications
- Article number: - Type : - Hardware : - Size : - Weight/m2 : - Packaging :		9017150330 Transfer paper for hard materials For conventional copiers/printers A3 (420 x 297 mm)/A4 (210 x 297 mm) 122 g/m2 100 sheets
Application
Pottery (coated) Wood Cardboard Metal Aluminium
Copier/Printer settings
Heavy paper Mirror image
Commercial Heat Press Transfer Instructions
Copy on the unprinted side of CopyFUN Grey (mirror image). Unprinted sections can be cut off before transferring the image. Position the Grey transfer using heat-resistant tape on wood, cardboard, metal or aluminium. Close the press. The transfer time is 120 seconds. - Transfer onto wood and cardboard without an A-pad for 5 seconds. - Transfer onto metal and aluminium with an A-pad for 120 seconds. Peel off the transfer paper once it has cooled off.
Mug Press Transfer Instructions
Stick the Grey transfer using heat-resistant tape on the mug (not on the image and leaving a 3 mm border). Place the mug with the transfer + rubber band + Teflon (exterior) in the press. Close the press. The transfer time is 120 seconds. Remove after 2 minutes and allow it to cool off in a bucket of water. Peel off the transfer paper once it has cooled off. Place the mug in a pre-heated oven for 5 minutes to bake at 225 °C.
Tile Transfer Instructions
Stick the Grey transfer using heat-resistant tape on the tile (not on the image and leaving a 3 mm border). Place the heat-resistant A-pad mat on the tile. Close the press. The transfer time is 120 seconds. Remove after 2 minutes and allow it to cool off in a bucket of water. Peel off the transfer paper once it has cooled off. Place the tile in a pre-heated oven for 5 minutes to bake at 225 °C
Important
High pressure Temperature 165° Celsius Transfer time: 120 seconds *The image will be glossy and the pottery will be dishwasher-proof after it has been in the oven. Basic Technical Paper aims to deliver an optimal product. All our transfers are, therefore, tested on the most common copiers/printers. We can not, however, guarantee that this product will be appropriate for every type of copier/printer. We recommend that you test the appropriateness and quality of your combination of equipment and transfers prior to production. Basic Technical Paper cannot be held responsible for any direct or indirect damage and/or injury that may ensue from the use or attempt to use this product.